- Deodorizing cat litter tofu litter800x480, 7.5-inch E-Ink display HAT for Raspberry Pi

Title Default Title
Qty:

Description

  • 800x480, 7.5-inch E-Ink display HAT for Raspberry Pi
  • No backlight, keeps displaying last content for a long time even when power down
  • Ultra-low power consumption, basically only for refreshing
  • Standard Raspberry Pi 40-PIN GPIO extension header
  • Supports Raspberry Pi series boards, Jetson Nano
  • SPI interface, for connecting with other controller boards like Raspberry/Arduino/Nucleo, etc.
  • Onboard voltage translator, compatible with 3.3V/5V MCUs
  • Comes with development resources and manual

This is an 800x480, 7.5-inch E-Ink display HAT for Raspberry Pi has embedded controller and can communicate via SPI interface. It displays only black and white.

Due to the advantages like ultra-low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instruments, and so on.

  • 1x 7.5inch e-Paper
  • 1x e-Paper Driver HAT
  • 1x RPi screws pack (2 pcs)
  • 1x PH2.0 20 cm 8-Pin

Outline dimension: 170.2 x 111.2 mm

  • Outline dimension: 170.2 x 111.2 mm
  • Display size: 163.2 x 97.92 mm

Website

  • Operating voltage: 3.3 ~5 V
  • Interface: SPI
  • Dot pitch: 0.205 x 0.204
  • Resolution: 800 x 480
  • Display color: black, white
  • Grey scale: 2
  • Full refresh time: 5s
  • Refresh power: 38mW (typ.)
  • Standby power: <0.017 mW
  • Viewing angle: >170°

Symbols:

  • VCC: 3.3 ~5 V
  • GND: Ground
  • DIN: SPI MOSI pin
  • CLK: SPI SCK pin
  • CS: SPI chip selection, low active
  • DC: Data/Command selection (high for data, low for command)
  • RST: External reset, low active
  • BUSY: Busy status output, low active

Note: Revision V2 has been released on 2019.11, the resolution is upgraded to 800 x 480, from 640 x 384 of V1. The hardware and interface of V2 are compatible with V1, however, the related software should be updated.